Heh, just wanted to show off my new crappy reball catcher made out of a monsterball box, masking tape, duct tape and rolled up grocery bags
this is the top part where the balls go in, the little two tabs on the inside that aren't covered in duct tape are so that balls don't fly back out when they go in, since they will hit the prong (from the inside) and then fly back in
there is also a little spout on the top left corner with the tab made of duct tape, thats so that you can pour out the reballs which you've shot into the box
I stuck my camera down into the hole for shooting the reballs and took a picture, this is the two peices of cardboard I cut off the top of the box (normally holds the handle in place) which I duct taped and taped on top of a mound of grocery bags which will padd the reballs hit, thus reducing the chances that they will pop out, and increasing the chances that the balls will not puncture the box
backside/sides of the box, which show reinforced taping and the handle cardboard peice literally taped onto the side, allowing you to easily transport the amazing reball catcher
what have you guys done?