Just curious how everyone else has their dm13/14 reach trigger set up.
I have my trigger set up for semi, its what i use most.
I'm trying to get it to be as responsive/fast as possible, obviously lol
Here is how i have mine set up ATM....
REACH: Just about all the way in, so that it sticks out as little as possible, but when there is a trigger pull it stops just short of making contact with the frame.
SPRING: Taken out
SPRING SCREW: Almost all the way out. If i took out my spring should i take the screw out as well. Any downside to that?
PRE: With the reach set almost all the way in, i have my pre-travel as long as it can be. (which isn't very long with the REACH as far in as it can go)
POST: As minimal as possible, while still allowing for full depression of the micro switch, stopping just short of making contact with the trigger frame.
So those are my settings. This is my first DM so im new to their triggers. But i also have a DM13 being shipped so i would like to set up both the triggers the same, with the best settings for semi.
Any input/help would be greatly appreciated!