[havoc531]

Does anyone know if QEV threads are the same as the mounts used on an Etek? I do know that they wont fit on an Etek. Just curious. Yes I did post this in the Etek forum, but its dead.

Thank you!

[garticus]

If you know they wont fit....why are you asking then?

You wanna install a QEV on the E-Tek?

[havoc531]

I know they wont fit due to space constraints with the stock frame. I milled an XSV frame to fit an Etek, so there should be room for the QEVs, just not sure about the threading.

[garticus]

If you have got a QEV....there's one way to find out

[havoc531]

lol thanks

[dmansr25sd]

Originally Posted by havoc531

I know they wont fit due to space constraints with the stock frame. I milled an XSV frame to fit an Etek, so there should be room for the QEVs, just not sure about the threading.

no it shouldn't, the thing is if memory serves me correct the fittings were offset from the center line so the qev's would still hit the frame without the rammer housing to be remade with ports on centerline and then the body drilled and a new frame added

[havoc531]

thats right, now i remember- i think jack wood mentioned that in the etek forum somewhere