velocity creep - PbNation
Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Archived Thread - Cannot Edit  
Old 05-08-2001, 01:20 AM #1
Join Date: May 2001
Location: Fredericksburg, VA
 has been a member for 10 years

I think I have a slow velocity creep in my 2000 lcd angle-
What could the problem be? I use a preset tank at 800 psi.
Dust is offline  
Old Sponsored Links Remove Advertisement
Old 05-08-2001, 08:42 AM #2
DarkRipper's Avatar
Join Date: Apr 2001
Location: VA
Annual Supporting Member
DarkRipper is a founding member
DarkRipper is BST Legit
DarkRipper donated to help Peyton Trent
DarkRipper helped look for balloons
DarkRipper owns a Planet Eclipse CS1
DarkRipper is Boss
DarkRipper supports Ninja Paintball
Try taking your minireg apart and cleaning the goop out of it. Also check your orings throughout the gun for nicks.

Finally, some of the miniregs came with the internals set up wrong. There are diagrams at AOG that show how to set it up right.

You may want to have an angel tech check it out if you don't know how to do that stuff.

My old feedback
My new feedback
With age comes wisdom, which is why DR is the smartest guy in the world. - Paint_hore

Please read and rate my reviews! =) ---> Here!
DarkRipper is offline  
Old 05-08-2001, 10:04 AM #3
angelusr's Avatar
Join Date: Feb 2001
Location: California
 has been a member for 10 years
You're going to want to have your Tank pressure checked, make sure that is not spiking. You're also going to want to have your minireg and LPR pressures checked.

Tank PSI=800psi
Minireg PSI= 400psi(if LCD) 475psi(if LED)
LPR PSI= 85-90psi
-The Edge Is Strong-
angelusr is offline  
Old 05-09-2001, 12:46 AM #4
"Child of the fall"
widdow's Avatar
Join Date: Apr 2001
Location: Paso Robles
 has been a member for 10 years
My friend had this prob at the pan am LA, the bonebrake guy told us how to fix it. The on off pin depressor can be screwed in too far restricting air flow, after sitting for a moment the pressure will creep back to normal, you shoot and it drops the pressure down again, then the cycle repeats. The solution is to screw the pin depresson in JUST until the air starts to flow to the gun then turn it 1/4 more of a turn. You should be set. Or you can buy a good ajustable
widdow is offline  

Posting Rules
Forum Jump