Need to put a E2 to 15 bps

blitz121 · 02-28-2010, 10:00 PM

hey guys I am new to e2s and need some help putting it to 15 bps

Shadow Crow · 03-01-2010, 05:35 AM

the best way is to reduce coff, leave cdel at 8

Rebel_816 · 03-02-2010, 01:40 AM

factory fast, psp ramping.

if you turn the eyes off the board will cap itself at 12. but with paint it will be 15.

Fortality · 03-02-2010, 08:14 AM

an e2 will not shoot past 15 in any ramping mode.

CRefakis109 · 03-20-2010, 09:41 PM

This is true.

CRefakis109 · 03-21-2010, 07:27 PM

the e2 will ramp at 15 (capped at 15) in psp mode, but this is for v 1.1 and 1.2 only. I use an MQ2 so I'm not sure what timing settings would be good for the hammer/sear setup. Just keep in mind that maximum ROF = [1000/(CON + COFF + CDEL)], and that the CON can be set as high as you want because using it with the eye reduces it to the lowest functional setting.

CON controls how long the bolt is back for, so if you set your CON to 40 and the eye detects a ball at 20, the bolt will close at that moment. So set it as high as you want if, but if not using an eye, the CON is extremely important to get right.