[pbmagnet4]

ok i fixed the drop off, so now im chopping. im chrono'd at 250... could it be my halo on low batt's? its not my barrel, my bore size is 691 and for some reason paint rolls out the barrel and they are split in half's, but there is no break in the breech or barrel?? my eye settings are what the manual suggest also.

[ihaveorracle]

check your halo make sure the batterys are working...if not it might be the paint you are using?

[pbmagnet4]

warped monster balls and midnigh

[IMPY~[e^A]]

Check your ball detents if the paint is rolling out of the breach. Put new batteries in your halo. I am going to say it is prob your paint though.

adaM.

[T-Ion]

i am chopping still and anyone knwo any place that sells good high quality paint online

[ihaveorracle]

ok I know monster balls=, bonus ball is alright along with midnight

is it cold out? I know where I live(socal) we have been having a cold front and yesterday when I went ballin my paint was so frozen that it was a chop fest...

[pbmagnet4]

detents are good im guessing/hopeing its the batteries and paint, cause it shot soooooo nicely today at my feild, and it was useing a reloader b and dye throttle. also outdoors were i shot it was 30 degrees and raining with wind.

[T-Ion]

alright i had the same issue with my reloader b but with my vlocity itss fine and rips try adjusting your bip delay taht will probably fix it tell me how ti workjs out id say put it on 5 or 6

[TomSpace]

if you are chopping then there should be paint all over the inside of the feedneck part of your halo.

[pbmagnet4]

no paint is in the feedneck or halo all in my barrel

[Cerealkillerz]

settings on gun and loader...

[pbmagnet4]

pre z code halo be
21 bps low batts