[E-S.W.A.T (Banned)]

So, at my field. hopper broke right. and i bought a hybrid shell. so i put it in my Qlock and 2 my surprise.....it fits. but its super loose. is there neway to make this tighter?like i thought of tape. but when i take hooper off, won't the tape all just come off? I plan on seeing if it will go on my Onyx feedneck

[Adrenaline-Junkie]

Tighten the clamp on the Qlock, duh. lol

[Kolder]

Electrical tape works well. Make sure to pull the clamp back tighten the scew and then put the clamp back.

[E-S.W.A.T (Banned)]

i tightened it, common sense. du. wold the electrical tape fall off once i take it out tho?

[UberSkeet_2]

Depending on how tight its in there and how hard you pull it out the tape would get all messed up.

[E-S.W.A.T (Banned)]

so you recoomend, electrical tape over scotch

[UberSkeet_2]

Yeah, or a piece of paper rolled up works, thats what I did when I had an egg. It worked a lot better than changing the tape everytime I took the hopper out of the feedneck.

[p8baller18]

Yes, use electrical tape.

[GuitarDrainer]

Like Kolder said, make sure you are tightening the feedneck while the clamp is open. Then close the lever

[Kolder]

Originally Posted by GuitarDrainer

Like Kolder said, make sure you are tightening the feedneck while the clamp is open. Then close the lever

That is what I meant to say but I could not fin the proper words.