Ok so heres the problem. I installed my S1v3 and today when I aired it up the bolt shot forward and then wouldnt even return or if any at all. I just kept doing these little 1/4 in. movements back and forth. I have no clue whats going on but I need some help. Im using the tophat bolt stop and the s3 if that helps any.
Is it a possible solenoid issue? It might be stuck in the "popped" position (I wouldn't know how, perhaps a piece of dirt or bad board), and because (I assume) you're using a stage 2 (or stage 5) that you wouldn't have any air coming out through the bolt. My suggestion is to make sure your noid is functioning properly, that you haven't crossed the mid and rear banjos (I know this is a ridiculous comment, but who knows), and that you have enough inline pressure to allow the forward air-chamber to push your bolt back.