when you pull the trigger....it activates a switch(trigger button) which send a current to the board and redirects the current to the noid and turns on the electro magnet which pulls the ram in side of the noid which lets the air flow change which pushes the ram forward and the ram hits the popit, and the gas from behind the popit goes throught the valve and out the front of the gun shooting the paintball.....
UGH FINE lemme turn on my music first so im not completely bored out of my mind......ok..... this might take a while and there aiint gunna be a shortened version
you skrew in the tank.... youskrew in the on/off nob... the preasure in the tank equalizes in the hose and goes to the hpr, the hpr pressurizes and when pressurized percisely to the velocety it is set at it the spring will compress and let off the valve, once that happens you have one shot of air. meanwhile there is a small hole inside the front block which presurrizes the lpr which functions in the same way as that hps but with a much lower pressure, befor the hpr spring lets the valve close the pressure makes the ram move back which also brings the bolt back.
The noid is in stand by position and when the marker is turned on and the trigger is pulled the switch that is clicked sends an electronic current to the electronic board of the marker which redirects the current to the solenoid(all this takes a few nano seconds if that) the solenoid's electromagnet is switched on for a extremely short period of time in which the noid's ram switches position which alows the air from the lpr to force the ram forward along with the bolt.
when the ram is in the completely forward position it hits the popit which releases the air from the hpr through the valve and into and out the bolt shooting the projectile out of the marker.
during this time the tank repressurises the hpr and lpr bringing back the ram to the rear position. where the cycle starts again.
eyes see the ball which send a signal to the electronic board(if in a certain mode) and the programing on the board will allow the current to be sent to the noid for the marker to fire
when the tank is skrewed into a gun the pressure make the macro line expand a tiny bit which press' the out side of the macro against small o-rings inside the macro fitings allowing a leak free fit