Microswitch Question... - PbNation
Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Archived Thread - Cannot Edit  
Old 07-27-2006, 04:38 PM #1
ROSCO's Avatar
Join Date: Mar 2005
Location: OREM,UT
 has been a member for 10 years
Microswitch Question...

I have a WAS 2.9 with the switch mounted in the frame and I have to replace it. How do I connect it. I mean there are three little plugs comming from the microswitch but two wires. Which do I connect? Also what do I do with the third one little plug? I don't want extra voltage hang'n around. Thanks...
Sometimes you just have too...
ROSCO is offline  
Old Sponsored Links Remove Advertisement
Old 07-27-2006, 05:06 PM #2
paintballer187's Avatar
Join Date: Dec 2001
Location: U.P. of MI
Annual Supporting Member
paintballer187 is a Moderator
paintballer187 is a Supporting Member
 has been a member for 10 years
paintballer187 works for a Paintball manufacturer
The blue wire goes to the middle of the switch; the yellow goes to the side where the lever connects to the main body of the switch. The third connector is to close a circuit when the trigger is let go. You can snip the extra connector off or leave it on there; either way it's not going to hurt anything.
paintballer187 is offline  

Posting Rules
Forum Jump