Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 11-09-2013, 07:05 PM #1
Joeottoman™
 
 
Joeottoman™'s Avatar
 
Join Date: Apr 2007
Location: Earth
Question Intimidator laser eye splicing.

So I have a set of old yellow laser timmy eyes and for the life of me I can't figure out how to splice them and get them to register as a ball in chamber. I've mixed and matched countless amounts of combinations with the eye wires and I can get the laser to show in the chamber, but still no luck with it registering. Has anyone by chance done this before and have any advice? I know I've read timmy eyes can work in the wrath.
Joeottoman™ is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 11-10-2013, 09:12 PM #2
tacxplosion
 
 
tacxplosion's Avatar
 
Join Date: Sep 2007
Location: Guatemala (for real)
Timmy eyes are too big for the wrath's holes, the wrath uses 3mm eyes, the timmy uses 5mm eyes. The additional current draw for 5mm eyes might be too much for the board's output, though with the capacitor on there I kind of doubt it.

Go to http://www.scenariodreams.com/manual...al_install.htm and look at the eye connectors underneath the ion connector, the leftmost is a wrath connector.

I went the other way around; used 3mm laser eyes in a timmy, had to make some spacers.
tacxplosion is offline   Reply With Quote
Old 11-11-2013, 12:37 AM #3
Joeottoman™
 
 
Joeottoman™'s Avatar
 
Join Date: Apr 2007
Location: Earth
Much appreciated man I will look into this.

I must have a set of 3mm timmy eyes because they fit perfectly into the eye holes.

It might be because I have a virtue board but I have big doubts about that. They would probably design the board so that wouldn't be a factor.
Joeottoman™ is offline   Reply With Quote
Old 11-11-2013, 01:31 AM #4
Joeottoman™
 
 
Joeottoman™'s Avatar
 
Join Date: Apr 2007
Location: Earth
Finally figured it out thanks for that link.

For anyone trying to splice laser timmy eyes to work on the wrath, splice the brown wire to the brown wire and black to black like normal. The other set needs to be yellow to black, and black to blue.
Joeottoman™ is offline   Reply With Quote
Old 11-11-2013, 01:33 AM #5
tacxplosion
 
 
tacxplosion's Avatar
 
Join Date: Sep 2007
Location: Guatemala (for real)
The only 3mm laser timmy eyes I've ever seen are the predator eyes, they usually come with 5mm spacers though:
http://www.theangelguy.com/Predator-...ator_p_19.html
http://www.theangelguy.com/Predator-...ator_p_17.html
tacxplosion is offline   Reply With Quote
Old 11-11-2013, 01:40 AM #6
Joeottoman™
 
 
Joeottoman™'s Avatar
 
Join Date: Apr 2007
Location: Earth
Yea you were right. The eyes fit, but don't stay straight. I'm just going to enlarge the eye holes with a drill.
Joeottoman™ is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump