Yin Yang Delimma - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 11-10-2002, 01:49 AM #1
F00
 
 
F00's Avatar
 
Join Date: Sep 2001
 has been a member for 10 years
Yin Yang Delimma

I have a Sonic Yin Yang bolt in my 2k1 STO and it is a real snug fit.

It is delrin and I know I'm not supposed to oil, but when I play it seems the bolt is so tight that it seems to hesitate and I chop a lot of paint. But when I put oil on the bolt the problem seems to go away.

Will the oil do any damage to the bolt?

And why the heck is the bolt so fat?
__________________
Evil Odyssey

Archangel *way of life*
F00 is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 11-10-2002, 02:02 AM #2
kerdon
mmmm Sarcasm
 
kerdon's Avatar
 
Join Date: Mar 2001
kerdon is a Supporting Member
kerdon is a founding member
 has been a member for 10 years
Oil over the short term wont hurt it over the long term it may. Bolts are made to a general diameter to fit every autococker out there......they are variations in the bolt and in the bore of your gun.
kerdon is offline  
Old 11-11-2002, 02:06 PM #3
jjmorin85
Born again newb...
 
Join Date: Dec 2001
Location: SW Ohio
 has been a member for 10 years
my warped sportz delron bolt fits perfect in my gun but is a total pain in the butt to get through my back block, i have to pull on it about as hard as i can to get it out of my gun. it goes in ok though. so i think just the back part of the delron was slightly swolen when i got it. i dont know if it would be ok to sand the back down a little or if i should continue to use it like this, because like i said, it fits perfect in my gun and performs flawlessly, just real hard to get out.
__________________
Born again newb...
jjmorin85 is offline  
Old 11-11-2002, 03:29 PM #4
ReTro Boy
Team Super Smurfs
 
ReTro Boy's Avatar
 
Join Date: Apr 2002
Location: Providence, TX...pop. 7
 has been a member for 10 years
Prolonged exposure to oil or old paint that is not cleaned out will cause the delrin to swell...which would only worsen your problem.
__________________
ReTro Boy...Team Super Smurfs
"We're gonna smurf you up!"

Check my Feedback.
ReTro Boy is offline  
Old 11-16-2002, 08:07 PM #5
triple-c
Beastin' it Up
 
triple-c's Avatar
 
Join Date: Nov 2001
Location: C-Ville, VA
triple-c is a founding member
 has been a member for 10 years
My friend had the same exact problem with his Yin-Yang Bolt. I took the o-rings of and now its smooth as butter! It still seals perfectly, no blow back at all.
__________________
RICHMONDRiot

VT PAINTBALL
triple-c is offline  
Old 11-16-2002, 08:37 PM #6
fullstretch
 
 
Join Date: Sep 2002
Location: durham nc
 has been a member for 10 years
dye

get a dye bolt/block
fullstretch is offline  
 




Posting Rules
Forum Jump