Macro leaking problem - PbNation
Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Archived Thread - Cannot Edit  
Old 04-07-2006, 10:29 PM #1
Join Date: Jun 2005
 has been a member for 10 years
Macro leaking problem

hey guys i just switched over to using macro but i always have a leak, it only occurs at the 90* fitting and no where else. can you guys give me any help on how to prevent it from leaking or anything i can put on it to stop it. thanks
madpyro is offline  
Old Sponsored Links Remove Advertisement
Old 04-07-2006, 10:35 PM #2
AGG is not cool
radlations's Avatar
Join Date: Sep 2005
Location: California SJ
teflon tape......

its like 1-2$ at orchards supply
Information about turtles and a great forum

Trust my feedback.

I Hate and the internet
radlations is offline  
Old 04-07-2006, 11:01 PM #3
Join Date: Jun 2005
 has been a member for 10 years
well i have that on the fittings going into the reg and asa but should i also wrap it around the end of the macro too?
madpyro is offline  
Old 04-07-2006, 11:47 PM #4
Maverick says :tup:
careyman_462's Avatar
Join Date: Aug 2005
Location: TN
Just make sure the line is cut very clean and straight (razor knife is great), and make sure it's pushed in all the way. If it still leaks, you may have a defective fitting.
Old PbNation Feedback
careyman_462 is offline  

Posting Rules
Forum Jump