[Medic1213]

I was checking out a Tech Site for the I3 goggle system, and it said this.

ADJUSTABLE FACE MASK
The Invision3 features an industry first adjustable face mask. Utilizing two adjustment holes in the frame, you can custom fit your I3 for a loose or closer profile to your face. In today’s game, half an inch can make all the difference in the world.

I don't see anything in the manual about adjusting the mask, and I don't see any holes in the frame that would appear to adjust the mask fit. Can anybody tell me how to adjust the fit of the mask frame to the face?

Thanks.

[jack9]

there are 3 holes on the top corners of the lense frame. to make the mask skinnier u put the tab in a hole closer to the front of the mask. if u have any questions pm me.

[Medic1213]

Thanks bro. That was easy. I can only adjust the mask by one hole on either side because the third hole is much smaller. Will the tab fit into that smaller hole too? I couldn't get it, but maybe I didn't try hard enough.

[jack9]

yeah i noticed that the 3rd hole was too small for the tab too. but imo its fine in the 2nd hole. i was going to try to make the 3rd hole bigger with a drill bit by just a little bit for the tab to fit in. but i didnt because like i said its fine imo in the 2nd hole

[Medic1213]

Based on how much force was needed to get the pin to the second hole, much less even close to the third hole, I'm betting that it wasn't designed to fit past the second. That definitely makes a difference in how round the mask appears from the front. That's one of my main gripes I've had with my I3... It makes my head look way too round. Now it's a lot better.