[Swantonbomboy]

Hey I just got this Whippersnapper strap. It seems a litte stretched but so have some of the straps I've seen around here and they dont seem bad when they get on the mask but my question is how do I go about installing the strap. It's different from the normal new style straps.

Here is a pic. I'm not sure where all the tabs go and if I can adjust it to get any smaller after I do the normal adjusting piece on the right so that the whole strap is dual layered.

There are two identical tabs. One on the left and one on the right and there is the adjustment strap in the center. I'm jsut wondering if I can install it to make it smaller or if there is something I can do. I'm a noob to straps and stuff so bare with me.



Thanks

[Matrixp8ntballr (Banned)]

cut all the plastic off and put the straps in the slots on the frame as normal, then the end of the strap that has the loop you pull under the foam on the end of the frame and fold it along the inside of the mask, pull it through till its tight. Bam, there you go.