[Colreb]

Hey there,
I was trying to adjust my trigger and well, oops, the spring popped out. Anyway, something is catching when I turn on the LED. Instead of the LED going straight to 4C eye and semi-auto uncapped, it goes straight to Frenzy 5.0. This usually happens when the trigger and the button are held down together to allow you to change settings. So, I think something is catching on the sensor, but don't know how to fix it. Any suggestions? Also, there is a little groove on the trigger just below the top two holes right above the two adjustment screws, is where the spring sits? Finally, I know something is catching with the trigger because when I take it out, the LED goes back to the main frame when you don't hold the trigger down.

Please help
Sincerely,
Col. Reb

[eskeoto]

Your trigger is set too tight if you are going straight to program mode. It works off of a micro switch so set it so it doesn't activate the switch until 3/4 of the way through the pull. You can use a pen spring in a pinch, but you may have to mod the spring to get the tension right.

[Colreb]

Thanks,

You're a genius LOL

[Colreb]

What's the bottom screw on the trigger for?

[eskeoto]

The bottom screw is for the trigger stop.