[DravenTheShocker]

Like the title says.. I took mine apart, everything was out except the board, and I couldn't find anything.

Thanks,

-Draven

[Vern1]

Look at the right side.
There is a cover held in place with three screws over the board.
There is a small cover on there about 1/4 of an inch in diameter.
Pry this out and under that is a pot.
Turning it to the right makes it more sensitive.
Get the instruction sheet, it has details about how to adjust it for best use.
We wire them into the trigger soleniod switch, so it doesn't matter.

[Terry2562]

See "what's the deal with the warp".... Sorry I was slow in responding, hopefully I shed some light on the setting issue.... Terry

Oh yeah... What Scorch said and what Vern said also....

[Vern1]

Greetings,
First, a small mistake on my last post.
We have two of the AGD ones in house and two of the PTP Warp Feeds.
The two PTP have an small cover you can take off to adjust sensitivity and the AGDs don't.
Go figure....
Anyway, if you take the black side cover off, there is a small blue pot you use to adjust sensitivity.
Since I use a cable, sensitivity is not an issue with me.
Again, my mistake....