Have a Wrath that is breaking or being slow?? READ THIS.
Ok there are alot of threads recently about Wraths breaking balls or being slow. Here are some ideas on how to fix this.
1. Basic stuff
-Make sure your paint is new and fresh
-make sure paint fits barrel (paint being too small for the barrel is better than paint being too big).
-New batteries in gun/hopper?
-Gun at right pressure? (250-260psi)
-Gun at right velocity? (Wrath works best 280fps and below.
-Paint covering eyes? clean the paint off! presto!
-Check bolt for burrs, buy upgrade bolt, or chamfer bolt top to reduce hop-up. (check stickies on how to chamfer/where to buy new bolt)
-Buy upgrade board to have better settings. Virtue, Lucky, and T-board.
-Is your hopper fast enough?? If you have upgrade board an Apache, Egg, Halo B, Reloader B, and Q-loader will all work. If you don't have upgrade board try only using forcefeed hoppers (halo B, Reloader B, Q-loader)
-Need new detents? If your detents are broken/damaged it might be blocking or breaking balls, buy new ones.
3. Being slow?
-It might just be you...(no offense)
-Most of the above ways solve breaking will also solve a slow wrath.
-trigger tuned properly?
-Need new trigger? FBM makes great triggers that have faster return rates.
-New board? They solve some chopping problems and make your gun much faster! (I listed new boards above)
-Fast hopper? Same reasons as above.
-New bolt? reduces hopup, and blowback for faster loading.
I probably missed alot of stuff so add on if you want. Hopefully whis will reduce the number of posts about these topics.
Wrath Legion-Devil Division- from da beginin'
spudnkyl delrin bolt
bl torpedo reg
T-Board (vers C)
Fbm wave trigger
Last edited by jjdustr340 : 01-18-2006 at 10:29 PM.