WarpFeed Problem - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 07-28-2001, 01:23 PM #1
Lancelot_AC
 
 
Join Date: Jul 2001
 has been a member for 10 years
WarpFeed Problem

Hello all. How do i adjust the sensitivity on my PTP Warp Feed. I have it on my angel but it just wont spin. LMK how i adjust it. Thanks
Lancelot_AC is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 07-29-2001, 11:17 AM #2
Geydo Dog
 
 
Geydo Dog's Avatar
 
Join Date: Jul 2001
Location: Wisconsin
 has been a member for 10 years
adjust

the first thing to do is to make sure that you have the warp set for the sensor in the feed and on the sensor on bracket,than i have mine set for about 1 o'clock for sensived,by taking your finger and tapping the warp feed it should spin ,than tap the bracket,if it doesnt spin the wire inside came off most likely is the cause,this is how i set up mine ,it works awsome,and if that wire did come off,just place it back on

good luck
__________________
Blue Dark Angel with warped feed
Red LCD Angel
Team Vision
Geydo Dog is offline  
Old 07-31-2001, 05:56 PM #3
mikeSaint
PHAT CRONIC BLUNT
 
Join Date: Jul 2001
 has been a member for 10 years
my friend has some problems with his warp feed as well (the warp feed not being able to spin). but.... this is normally caused by paintballs that are in bad condition (having oil on them, or being sticky, etc).
later.
__________________
mikeSaint from pbc

32 degrees Black to light blue fade cocker... NICE!!
Pimped out 99 Autococker
Nova 700 (leaking :-( ).
mikeSaint is offline  
 




Posting Rules
Forum Jump