Dyna flow leak?!?! - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 07-26-2001, 06:28 PM #1
bunkermonkey15
werd
 
Join Date: Apr 2001
 has been a member for 10 years
Dyna flow leak?!?!

ok i have my dyna flow and it leaks on the from were you adjust the input pressure. i really dont know whats up. you guys know dyna flows web site or #. or how to fiz this problem?
bunkermonkey15 is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 07-26-2001, 06:30 PM #2
Skyssx
 
Join Date: Mar 2001
Location: Fort Gordon GA
 has been a member for 10 years
Dynaflows are hyperflows and are made by centerflag products at www.centerflagproducts.com I think all the dynas have on/offs, turn the tank off and unscrew the adjusting cap all the way, then get a seal kit and replace all the seals. If you still have problems you may have to send it in.
Skyssx is offline  
Old 07-27-2001, 01:03 AM #3
CenterFlag
Awaiting Email Confirmation
 
CenterFlag's Avatar
 
Join Date: Apr 2001
 has been a member for 10 years
Sounds like you need to clean and regrease your reg..
With the air turned off.. unscrew the output pressure adjuster all the way.. inside you will find a spring, and a brass piston.. Check and make sure the o-ring on the piston is in good condition..
Wipe all surface doen with a rag..
Tighten grub screw in top of brass piston all the way then back out a 1/4 turn.
Grease o-ring with white lithium..
Re-assemble.. Get a full fill and reset your output pressure to 600 PSI..

Anything else??

CF
__________________
CenterFlag Paintball Products
Company Email:Firstout9@aol.com

Primary Email: centerflagtech@yahoo.com
CenterFlag is offline  
 




Posting Rules
Forum Jump