[1andonlyagain]

http://www.custompbsolutions.com/ind...rodID=593&HS=1
or
http://www.scenariodreams.com/oscomm...products_id=66 + http://www.scenariodreams.com/oscomm...products_id=69

Thanks a ****load!

[timmy owner]

i would get the T-board with ramp. Cause if you get Zip Kit, you dont really have an eye.

[1andonlyagain]

How hard is it to install? And how do I set-up the eyes on the Tboard?

[shocktroop]

Just take out the old an in with the new.

You first gotta choose bounce or break. Most likely break
Well you gotta go in first menu
First is Dwell
Second is eye Delay
Third is Debounce
Fourth is Eyeoff time
Fifth is Eye mode

So if you want to go straight to the eye, go in first menu and push the top button three times and pull the trigger once so the LED light stays lit and ur on bouncebeam. done...

[1andonlyagain]

Originally Posted by shocktroop

Just take out the old an in with the new.

You first gotta choose bounce or break. Most likely break
Well you gotta go in first menu
First is Dwell
Second is eye Delay
Third is Debounce
Fourth is Eyeoff time
Fifth is Eye mode

So if you want to go straight to the eye, go in first menu and push the top button three times and pull the trigger once so the LED light stays lit and ur on bouncebeam. done...

Ya, I saw SUBzero's vid on scenariodreams.com but I still cant tell if there is any sodering needed or anything. Also can you tell me the diffrence between break and bounce, How do I use the stock eyes and I don't need dwell or debounce with a TES (only has new reg/bolt)?
Thanks!

[T1rippaman]

my theory is: if you don't need debounce, then what is the point of having a tboard? Maybe so the eye can see darker balls, but i see no other reason, unless you want ramping. it is a waste of $70+ if you buy the tboard and chip.

There are people who dye their bolts solid black, and the eye still sees it.

[Dead_Bunny]

dont forget about the t-kit i mean its like the best of both worlds

[1andonlyagain]

Originally Posted by T1rippaman

my theory is: if you don't need debounce, then what is the point of having a tboard? Maybe so the eye can see darker balls, but i see no other reason, unless you want ramping. it is a waste of $70+ if you buy the tboard and chip.

There are people who dye their bolts solid black, and the eye still sees it.

I will need it soon, but right now I don't have a new trigger switch or anything in.

[shocktroop]

NO soldering needed.

T1rippa, the T-board i had couldn't read my fingers or my bolt. I liked that too but its power to the eye was way lower than the stock so it had feedback problems.... Alrdy shipped it out for a replacement

[1andonlyagain]

Originally Posted by shocktroop

NO soldering needed.

T1rippa, the T-board i had couldn't read my fingers or my bolt. I liked that too but its power to the eye was way lower than the stock so it had feedback problems.... Alrdy shipped it out for a replacement

How does the Tboard work with a Shocktech Bolt (black)?

[Dead_Bunny]

im not sure.....are you going to be using bounce beam eye or break beam eyes?
if the T-board does come out with a bounce beam i think it would work....but dont take my word on it...........