AGD Warp Sensitivity Adjustment - How? - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 08-04-2001, 02:33 AM #1
DravenTheShocker
J-Ting
 
DravenTheShocker's Avatar
 
Join Date: May 2001
Location: NH
DravenTheShocker is a Supporting Member
 has been a member for 10 years
DravenTheShocker plays in the PSP
DravenTheShocker supports DLX Technology
AGD Warp Sensitivity Adjustment - How?

Like the title says.. I took mine apart, everything was out except the board, and I couldn't find anything.

Thanks,

-Draven
DravenTheShocker is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 08-04-2001, 10:47 AM #2
Vern1
Timmy - WooHoo!!
 
Vern1's Avatar
 
Join Date: Apr 2001
Location: Pettytown, Texas
Vern1 is a Supporting Member
Vern1 is a founding member
 has been a member for 10 years
Vern1 helped look for balloons
Look at the right side.
There is a cover held in place with three screws over the board.
There is a small cover on there about 1/4 of an inch in diameter.
Pry this out and under that is a pot.
Turning it to the right makes it more sensitive.
Get the instruction sheet, it has details about how to adjust it for best use.
We wire them into the trigger soleniod switch, so it doesn't matter.
__________________
Cheers,
Joe Petty
Original Timmy Whisperer, Voider of Warrantys and Healer of Unicorns.
Petty Paintball - www.pettypb.com
Vern1 is offline  
Old 08-04-2001, 12:47 PM #3
Terry2562
 
 
Join Date: Jul 2001
Location: Kansas
 has been a member for 10 years
Draven

See "what's the deal with the warp".... Sorry I was slow in responding, hopefully I shed some light on the setting issue.... Terry

Oh yeah... What Scorch said and what Vern said also....

Last edited by Terry2562 : 08-04-2001 at 12:54 PM.
Terry2562 is offline  
Old 08-06-2001, 02:37 PM #4
Vern1
Timmy - WooHoo!!
 
Vern1's Avatar
 
Join Date: Apr 2001
Location: Pettytown, Texas
Vern1 is a Supporting Member
Vern1 is a founding member
 has been a member for 10 years
Vern1 helped look for balloons
Greetings,
First, a small mistake on my last post.
We have two of the AGD ones in house and two of the PTP Warp Feeds.
The two PTP have an small cover you can take off to adjust sensitivity and the AGDs don't.
Go figure....
Anyway, if you take the black side cover off, there is a small blue pot you use to adjust sensitivity.
Since I use a cable, sensitivity is not an issue with me.
Again, my mistake....
__________________
Cheers,
Joe Petty
Original Timmy Whisperer, Voider of Warrantys and Healer of Unicorns.
Petty Paintball - www.pettypb.com
Vern1 is offline  
 




Posting Rules
Forum Jump