[Liux43]

i looked inside my feedneck and tried to drop a ball down to see if my eyes work. the ball couldn't go throw, i could see my bolt if i look down my feedneck. that was what was stopping my ball, my bolt. i have a spundkl whatever black delrin bolt, any suggestions?

[shocktroop]

All i have to say is... make sure u put the pin in the ram correctly. You can actually make sure b/c u can see it go into the ram wen u plug it in! Where the milling is is where u can see it. so just move it slow untill u see it align with the hole for the bolt pin

[jjdustr340]

Liux---try turning the ram cap back a little. This will move the ram, and therefor the bolt, back.
If the bolt is sticking that far forward, disconnect the LP hose from the ram cap, turn it counter clockwise one hole turn, reconnect the LP hose, and rock and roll!