how do i set my conquest - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 06-25-2002, 09:03 PM #1
close_combat
 
 
Join Date: Sep 2001
Location: Batesville, IN
 has been a member for 10 years
how do i set my conquest

i just got a conquest put it on, and at the tournament I got two velocity penalties because when my tank got down to like 1000 psi, it would be higher than what it was. i now know that it puts out a greter output pressure when the tank gets lower.... So basically how can i prevent that or reduce the velocity increase. By the way i use the stock wdp reg on my angel. Also what should i set my conquest to...600?????, and then adjust the velocity with my reg. thanx for any help!!!
close_combat is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 06-26-2002, 12:18 PM #2
oxtail
 
 
Join Date: Apr 2001
 has been a member for 10 years
If u use, a second inline like your stock WDP reg. then that will take care of any spikes. MacDev recommends using a second inline reg to maintain good consistency, anyways. I set the Macdev at 600 or 650 psi to the WDP inline reg. and it worked fine.
oxtail is offline  
Old 06-26-2002, 01:26 PM #3
CockerMan86
 
 
Join Date: Apr 2001
Location: Naperville, Illinois
CockerMan86 is a founding member
 has been a member for 10 years
he does have the WDP as the inline, but if it is spiking you might want to check and make sure the WDP inline is clean.
__________________
Just back into the sport after being out of it for five years....my how things have changed
CockerMan86 is offline  
 




Posting Rules
Forum Jump