Originally posted by ES13Raven
What EXACTLY do you have to do to install the "impeller mod"?
What parts do you need & where do you get them?
I used a small hair dryer (heat source), pliers (to do the bending) and a screwdriver (as a stand).
Keep your rev handy to test the fit as you go.
The process is simple.
- heat the arms (individually)
- seperate them more so a ball will not get trapped on top of the impeller
- bend them upward a bit so they won't touch the sides when spinning -- also enough that they won't trap a ball underneath at the edge of the feedtube
test it... fix it.... play.