[Gibn]

Well , i have this sonic cocker with E2 . It was shooting fine until lately. It seems to be stuck in training mode. I haven't tried anything on it yet to fix it. any ideas on what i could try first?

[tlmiller]

A new battery.

[u238]

Check your hammer lug depth and the board's SON time, unless you mean that it's actually stuck on the mode. In that case, I'm not sure.

[cww516]

replace the battery first, it's very likely that the battery can't supply enough juice to drop the sear.

[nat]

Also check the sear molex plug on the board!

[mshue]

If a new battery doesn't work, try taking out the battery and leaving it alone for a couple days. Then put a new fresh battery in.

[Godmachine]

Originally Posted by nat

Also check the sear molex plug on the board!

.

Had the same problem not too long ago, stuck a piece of folded paper between the frame and the plunger and it fixed it right up (didnt have screw)

[andy27473]

Give the hammer lug a 1/4 turn,it could just be that the lug is marked.
Had the same thing with a black magic,played around with for hours when all I had to do was give the hammer lug a 1/4 turn and lubricate the sear.
Give it a go it may save you a lot of time.
Hope that helps

[Gibn]

well i tried a couple things, but nothing changed. its not on training mode and its not firing air at all, just cycles. where abouts is the molex plug?

[PBACE1]

increase input pressure?

[cww516]

Originally Posted by Gibn

well i tried a couple things, but nothing changed. its not on training mode and its not firing air at all, just cycles. where abouts is the molex plug?

it's the little white thing attached to the wires from the noid. molex is a brand or a category of plugs (don't remember which).