Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 03-30-2012, 10:19 AM #1
Istobla
 
 
Join Date: Mar 2012
Warsensor Zeus has spyder thread barrel!

Now that i have the attention of everyone who has ever owned a Zeus pistol or clone, i will explain.
A spyder barrel will not fit a zeus, but it is the same thread, 1.5mm, and the same diameter. the non threaded part is the only thing stopping it. If it were trimmed, it would fit, in theory. A couple of the paitball stores i frequent have barrel bargain bins, so i will pic up a spyder threaded barrel and cut it to fit and update this thread. Just wanted to put this out there because i have looked, i have found a lot of people asking where to get zeus barrels and noone offering up answers.

So, anyone know the best way to cut a barrel clean, without a lathe?
Istobla is offline   Reply With Quote
Old 04-25-2012, 10:56 AM #2
killeralibi66jr
 
 
Join Date: Apr 2012
i would get a copper pipe cutter from menards and then sand the edge with 400 grit paper. go very slow with the pipe cutter and dont tighten it to much or you will dent the barrel
killeralibi66jr is offline   Reply With Quote
Old 05-17-2012, 09:49 PM #3
killeralibi66jr
 
 
Join Date: Apr 2012
i did it i used a pipe cutter and it worked i have a 3" spyder barrel on my warsensor zeus g2
killeralibi66jr is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump