[killerfluffybunny]

Ok I looked at the links and i still need helps. Autocockers are my Kryptonite when it comes to markers. SO DUMB IT DOWN!!

I have a 1/2 Blocked System X autocker

PICS








ISSUES WITH TIMING

It is firing on the trigger pull back. <---- THAT IS ALL I KNOW!!!

[dirtraven]

switch the 1st and last hose on your 3-way, middle stays where it is. Your current setup is for a slide trigger.

[Dk-79]

pretty sure they used three oring shafts, like dye and shocktech. His hoses are right.

It sounds to me like your sear isn't catching the lug. Take off any air and try to manually cock the hammer by pulling the bolt back. If the hammer catches on the sear and stays locked back, it's all good.

If the hammer just goes back forward, remove the bolt, and using a 1/8th inch allen key, tighten the set screw that's in the top of the hammer one turn at a time until it catches the sear.

Then you can fine tune it, you want the hammer to fall near the front of the trigger pull, but not so close that it's unreliable. Tightening it will make the firing point later in the pole, loosening makes it trip sooner.

[dirtraven]

Originally Posted by Dk-79

pretty sure they used three oring shafts, like dye and shocktech. His hoses are right.

you r correct on the hose for the x-3way.

[abcito]

also make sure your sear spring is seated correctly

[Jaccen]

http://www.youtube.com/watch?v=_3nvh7e14ak

http://www.mcarterbrown.com/ravi/Art...t/ACTroub.html