I had to turn mine up to 8 or I would get shoot-down at high ROF. That seemed to help a lot but it still looses a little bit of velocity at high ROF.. Any ideas? I'm using a Max-Flo that refreshes fine.
-Alex
Angel4Life,
What input pressures are you running?
At first we were running about 220 -230 and got shootdown and starving of the front pneumatics.
We changed springs, rebalanced the pressures to the springs and are now putting 290 - 300 into the marker and eleminated the shootdown.
The biggest noticable problem with the LP gun was starving the pneumatics and not getting a consistent cocking.
Hope this helps!
__________________
Cheers,
Joe Petty
Master Airsmith
The Original Timmy Whisperer
Warranties Voided Expeditiously
Healer of Unicorns
Proud Host of 9 Viper Texas Triple Threat Scenarios
RIP Petty Paintball - www.pettypb.com
sam did you ever work on those settings you mentioned way back, what are yours at now, in fact, whats everyone got for their settings now? i just got my baby, its so sweet now i have to start tinkering
For the time being I'm going to use my revy with xboard and vortex, once the new Halo is ready I will switch back to the Halo. I'm getting similair results with my Revy as I did with my Halo.
SAM!- why did you choose to make your close time 6ms shorter than your open? Don't they say make it 3 or is there a way to find the optimum for each setup?
-Alex
I'm gonna lower the Open time angel4life. Open time and load time is one delay without the eye. I know some people were asking about efficiency, I got about 8 1/2 pods with my tank filled to 4000psi with about 900psi left in my tank, give or take 100 balls for error so I'm guessing 10-12 pods from a 68/4500. It's not the best but it's not to shabby.
the 4's came from the stock settings from pro pb. If I use the RIP software and try to lower it the settings go up to a 5. I saved the stock settings so I could use them again.