[teamNka]

ok i have a 03 shocker and just recently converted it from a max flow to normal has the following specs
bloodline va
hyper 2 reg
stock internals n havs a pear bolt guid
ok when i gas up the gun it leaks out the manifold full force from rite n left
been told The solinoid is bad so rebuilt it told mani was bad and replaced it baught a rebuild kit and did that n no luck to the point i wanna freak please help if u have ne ansers lmk u can message me here or txt or call at 8598018706

[grodo]

did you replace the sail oring on the bolt?

[Tempted (Banned)]

Did you use the solenoid manifold gasket?

[teamNka]

Originally Posted by grodo

did you replace the sail oring on the bolt?

first thing i did it seems like its going from tank str8 to manifold like no air to the bolt

[teamNka]

Originally Posted by Tempted

Did you use the solenoid manifold gasket?

used a brand new gasket and mani

[Tempted (Banned)]

This is going to sound dumb. Are you 100% positive that you did not install the solenoid backwards? If its the solenoid I think it is then it is possible to flip it 180 degrees. The screw holes will still line up.

[jim4130]

1) have you set the reg to 180 psi? Could be over pressurized and venting the noid.
2) bolt sail oring. I know you said you changed it but did you put the right size on? My buddys nxt one day would not seal no matter what oring I put on it from my oring monkey 10x kit come to find oring monkey accidentaly gave me orings 1 size to small I tried a bigger one and problem solved.
3) when all else fails zdspb.com this link will have your answer
http://www.zdspb.com/tech/mguide/sho...ifoldleak.html

[d-r0ck-1489]

^ jim knows all

[teamNka]

ill get back to yall on that stuff

[teamNka]

Originally Posted by teamNka

ill get back to yall on that stuff

still no luck is there ne where that will tech n service my gun

[lpmaster]

Originally Posted by teamNka

still no luck is there ne where that will tech n service my gun

So did your problems start after changing your reg? try just lowering your input pressure. if you have a gauge get it around 185-205psi to start

[fishballer06]

Originally Posted by teamNka

still no luck is there ne where that will tech n service my gun

There are quite a few places that service Shocker's.

[teamNka]

Originally Posted by lpmaster

So did your problems start after changing your reg? try just lowering your input pressure. if you have a gauge get it around 185-205psi to start

yeah because it came with a gas thru n i changed the sail o ring the whole manifold and still leaks out the exaust ports will a hyper 2 affect the pressure and for it to stop leaking ill turn the reg all the way down to itll stop leaking but then it wont fire

[jim4130]

Originally Posted by teamNka

still no luck is there ne where that will tech n service my gun

VVVV

Originally Posted by fishballer06

There are quite a few places that service Shocker's.

^^^^^ this is the guy you wanna talk to for services.

As for your reg issue you'll need to have a rough idea where your pressure is at. If its to high the noid will vent as a fail safe. A possible reason its not shooting when you lower the pressure could be bolt stick or some other form of sticking like the oring tollerances being to tight. I know bloodline guides are notorious for tight tolerances. I had to have mine turned down in the oring glands to make it work righ.

[teamNka]

pmd