[StealthLogics]

Anybody shooting the ndz or the pooty and wojld you recoomend them over stock i have the luxe 2.0 so i mean the new cores of the three
Are they quieter or smoother or uust a waste of money

[TheREVYman]

I am using a sprung 1.0 core at the moment but in past experience the 2.0 core is the best

[Giruc]

the luxe 2.0 core is awesome just shot it in 35 degree weather today no fsdo at all

[CGriff19]

i prefer my pooty core over my 2.0 core sound sig ball stack stability lower operating pressure super smooth cycle

[StealthLogics]

What does lower operating pressure do
Do yiu turn the velocity down to get the same fps
Therefore more efficiency?

[p.lovell]

Originally Posted by StealthLogics

What does lower operating pressure do
Do yiu turn the velocity down to get the same fps
Therefore more efficiency?

This and a softer touch on the ball.

[ROCKNROLLA]

I like my pooty core better than my 2.0 as well.

[KMA]

stock 2.0 works infinitely better than my polished/sprung 1.0 core.

[StealthLogics]

i have the luxe 2.0 so i mean the new cores of the three

[jmarcotte]

Plenty of threads on this already.

https://www.pbnation.com/showthread.php?t=3877038

https://www.pbnation.com/showthread.php?t=3856320

[Alexwarlock]

Stock power core 2.0

[gildy1]

i prefer the G-Core over all of them

[digital sol]

Ill be able to do a comparison in the next couple weeks. Currently have a stock 1.0 setup. Full pooty sprung setup and ordering the 2.0 setup. I also have a polished nox kilo bolt.

My goal is to run and test all 3 setups with operating pressure, consistency, sound, and with and without the feather touch. I have not been able to run the ft installed with the pooty setup but the gun is super smooth and consistent.

[digital sol]

Originally Posted by gildy1

i prefer the G-Core over all of them

More info on this? Finish looks ruff but writing this from my cell

[gildy1]

Originally Posted by digital sol

More info on this? Finish looks ruff but writing this from my cell

this was something I did about a year ago maybe more...and basically what I did was machine windows in the firing can to allow for easier access of inner can orings and lower op. pressure, I installed a spacer that fit into the center of the bolt and it did the same thing as a flat face bolt did, and then got it modded to allow for a spring. So basically, it shoots amazing, and the finish looks "rough" because it was a quick sanding of the outer can to get the anno off, its very smooth now.

[gildy1]

Oh, and with that core the FT is in and manifold is 3 turns in from flush

[digital sol]

Originally Posted by gildy1

this was something I did about a year ago maybe more...and basically what I did was machine windows in the firing can to allow for easier access of inner can orings and lower op. pressure, I installed a spacer that fit into the center of the bolt and it did the same thing as a flat face bolt did, and then got it modded to allow for a spring. So basically, it shoots amazing, and the finish looks "rough" because it was a quick sanding of the outer can to get the anno off, its very smooth now.

Well done sir!