[Vegard]

I normally take an old hopper, wrap some skate tape around the neck of the hopper so it barely fits the feedneck, tighten down and twist. Most feednecks that I've had issues with have come off easily using that method.

[new ion?]

I only own a halo. And I have to say after almost completely screwing the gun I'm a bit hesitant to do more

[Vegard]

Halos are sturdy enough, the threaded part on a plastic bottle also works.
I actually did this to my karni with the same feedneck on it a few days ago.

If the feedneck stub somehow flops off the body you can have necks pressfit directly into the body.

[new ion?]

It's almost tempting to slide a crap aluminum bolt into the body to stop the feedneck stub from twisting... and I would rather it not come off lol. That's money I don't need to be spending.

It's actually tempting to TIG weld the damn stub in place.

[Jasoncp47]

That is one sexy karni man. How much to do the coloring?

[dbkid0486]

damn the entire feed tube twisted? That's one sexxy door stopper.

[nutz4pb]

Looks nice, Good job!