[TheBoss33]

Yes, the stock spring with the Boss Bolt is not great. You can use it if you have to but remove the shock spacer and o-ring 1st. There are a few things that can cause your bad +/-. Bolt guide o-rings, poppet o-ring, bad paint barrel match (under bore if possible) and poor recharge rate on the gun or tank. Rarely but possible a sticky noid or weak battery.

[soflaballer954]

Wow you got empire and boss up in here! Thanks for the help guys!

[FOOPAgfp]

Originally Posted by EmpireTech

From what I can tell you is that when you are seeing a +/- 20 its normally the bolt guide o-rings that need to be replaced. Also the Boss Bolt what Version is it?? I don't think that any of them are suppose to work with the stock spring. They were designed to with lighter springs.

Thanks, I've switched back to the stock bolt now. I've cleaned and lubed the poppit, I'll replace the guide orings next. Unfortunately I don't have easy access to a chrono right now, so all I know is that I no longer have visible shoot down. That's a start at least.
Thanks again,
Collin

[FOOPAgfp]

Originally Posted by TheBoss33

Yes, the stock spring with the Boss Bolt is not great. You can use it if you have to but remove the shock spacer and o-ring 1st. There are a few things that can cause your bad +/-. Bolt guide o-rings, poppet o-ring, bad paint barrel match (under bore if possible) and poor recharge rate on the gun or tank. Rarely but possible a sticky noid or weak battery.

Thanks Boss,
For now I've put the stock bolt back in, once I get things up and running properly I'll probably be ordering a new bolt from you. For now, my next move is to get a cocker threaded back (just switched from an ion). The tank I'm using is brand new and working great with my ion, so I'm guessing if it's a reg, it's the relay. I was overboring, I'll try all the o rings, and if that doesn't do it then I'm thinking reg.

Thanks,
Collin

[FOOPAgfp]

Thanks EVERYBODY for all the advice.