My total cost is around 235 But you could go cheaper i replaced valve as well to a standard 2k valve insted of the stock delrin rubber valve it had got the gun for 100 then got a shocktech front block assembly for 75, bolt and sled was 40 or so its using an empire snipper bolt, sled, pin then the rest is just pieces I've had laying around reg, on/off, Ccm feedneck,
My goal was to do it at home/ with home style tools. I have access to a Cnc but for this gun I didn't wanna waste time on the mill and wanted to see how hard it really was to do from home. Everything has been done so far with a band saw and an air grinder in going to cheat and run the mill for 5 sec, to make sure I get the pin slot correct don't want it sideways with my cutting