[vesparider]

Seen a Freak Barrel I wanted on Craigslist and contacted the guy. Come to find out its the same person that I did some powder coating a couple years ago on a Rat Jr. So I bought it too. He was the original owner and in his 40's. Very well taken care of and shoots fine.

The Jr was originally silver now its flat black. Serial Number #394.
Has:
NDZ Feedneck.
E.C.S 1.10 Software
Thats about all I see that is changed. If you notice anything I missed Please post.

Plans?

Not sure yet.
*Drop forward Gone for sure. Like my BL Cam Drives. LOL
*Vertical Reg change? Any thoughts? Just want to make it a little lighter and tighter.

Any thoughts on where and what I need to look out for or suggestions are definately welcome.

[ripdisc]

any reg should work fine on there.
looks like a ndz or eclipse trigger.
the ecs software was always my fav. nothing much else to do to it really...looks like a titanium sp pin so im guessing there is an aftermarket bolt in there too

[vesparider]

Originally Posted by ripdisc

any reg should work fine on there.
looks like a ndz or eclipse trigger.
the ecs software was always my fav. nothing much else to do to it really...looks like a titanium sp pin so im guessing there is an aftermarket bolt in there too

I may snap a shot of the bolt later for identification.

I need to see what was offered on the rat vs rat jr. Early milling but not sure about other or any upgrades

[ripdisc]

hard to tell looks like an NDZ eye cover. some kinda aftermarket feedneck.
rats had a lot of the little necessities taken care of as far as coming with parts. looks like someone upped this one a bit too. if they got the ecs done id figure they had a good idea what they were doing!

[vesparider]

Originally Posted by ripdisc

hard to tell looks like an NDZ eye cover. some kinda aftermarket feedneck.
rats had a lot of the little necessities taken care of as far as coming with parts. looks like someone upped this one a bit too. if they got the ecs done id figure they had a good idea what they were doing!

Yeah it's an NDZ feedneck. I bought the marker from the original owner he is in his late 40's. He is like me tinkers more than plays.

[jtguy2269]

look into a aka 2-litre. personally my favorite regulator next to the bob long 360

[vesparider]

Originally Posted by jtguy2269

look into a aka 2-litre. personally my favorite regulator next to the bob long 360

The 2-liter seem to be scarce. Thought maybe I'd find an SFT reg that way my i can use my existing Oring kit from my shocker. Plus it's still sp and looks fine.

[vesparider]

Updated with pics.

[MutantSalivaWorm]

I have an iframe for sale, and a WAS board.

[Duece McCracken]

Originally Posted by MutantSalivaWorm

I have an iframe for sale, and a WAS board.

WAS board is imo the best upgrade to a stock imp. So much adjust-ability, i would get an LRP set-up with the board.

I-frames are nice, I shoot OTB 90 frames better. All personal choice of course.