Quote:
Originally Posted by aLienTeaBaGGer
You HAVE to take the short end of an allen wrench to adjust that screw.... I have a trigger very similar to yours and was going through the same thing when I realized that I could use the trigger height adjustment screw (its inside the frame behind the trigger guard) to set the trigger nice n close to the frame and also limit the amount of return travel.
|
The only thing is I tried using the short end of the Allen wrench and it would not fit because of the weird angle. So is their any kind of wrench that can get inside their despite the wierd angle.
close but no cigar so ill give you 500,000.
Edit: my dad said that cutting off some of the short end would work. Is this a good idea?