[sexygirlplayer]

anyone having problems w/this tank. i have the 68/3000 adjustable. my velocity is up and down when i check w/chrono. my gun is in perfect shape, using correct barrel and good paint. any ideas?

[Biohazard]

What kind of gun and reg are you using?

[sexygirlplayer]

i have an impulse w/maxflo. everything is lubed and cleaned. paint fits correctly in freak system. tank is full

[Biohazard]

Nice set-up. Make sure your locking nut is tight..

[sexygirlplayer]

locking nut?

[Tool]

I believe hes referring to the locking nut on the Max-Flo.

[siayajin]

What's the output pressure set at on the bulldog? Perhaps it's set too low?

[SuPrBuGmAn]

Generally you'll want about a 200psi difference between your primary(Bulldog) and a secondary(Max-Flo) regs.

[sexygirlplayer]

bulldog is set at 650 and maxflo is at 160

[siayajin]

You covered all the possibilities.

• clean and lubed gun
• clean and lubed maxflow
• fresh paint (I hope)
• paint to barrel match
• full tank
• pressure between regs

I would check the Bulldog's recharge rate. One of it's reg seals could be dirty and is preventing it from staying consistent. You'll need a reg tester to find this out OR just put it on your spyder and chrono. If the readings are also inconsistent then it probably is the tank. I have a teammate who used to have this tank and had a similar problem. No matter what he set the output pressure on the tank to, it still fluctuated to at least 900psi. He sent it back to ACI to get it fixed.

[sexygirlplayer]

first i will relube and clean gun, maxflo and solenoid. if they doesn't work, i'll try tank on a spyder. will also run the impulse on co2 and see if it still does it. thanks for the help everyone.

[The Great Morpheus]

i never had those kinda problem with my bulldog on my imp it was pre set. my velocity was always +/- 4