[Sniper/Paint]

Just wondering if there is anyway you can shorten the Vlocity feedneck. It sticks out pretty far on my PMR.

[broncosboy923]

just take sand paper and rub it evenly on the feedneck until it fits better on your *cough*cough*gay*cough*cough* pmr.
lol

[Sniper/Paint]

Originally Posted by broncosboy923

just take sand paper and rub it evenly on the feedneck until it fits better on your *cough*cough*gay*cough*cough* pmr.
lol

Gay hahaha good one. If your serious then you should look at the gun in your sig and say *cough*cough*gay*cough*cough* Mini. But anyways about the hopper I did that to my halo but the vlocity feedneck is a little different so I didnt no for sure.

[Vegeta_ss4]

Originally Posted by Sniper/Paint

Gay hahaha good one. If your serious then you should look at the gun in your sig and say *cough*cough*gay*cough*cough* Mini. But anyways about the hopper I did that to my halo but the vlocity feedneck is a little different so I didnt no for sure.

Just cut it down to size . Here is a how to.https://www.pbnation.com/showthread.php?t=1273426

[Euouae]

I used a hack saw, and then sandpapered it down a bit to make it smooth and even.

[Sniper/Paint]

Originally Posted by Vegeta_ss4

Just cut it down to size . Here is a how to.https://www.pbnation.com/showthread.php?t=1273426

Thankx a million man I just took it out like 10min ago and shortend it like a cm and a half. I never thought a saw would work I thought it would wreck it but it worked way better then sand paper. Sand paper is just for after touches.