odysey O3M cocker

infamous16 · 08-01-2005, 02:36 PM

these ne good? Are they upgradable?

tlmiller · 08-01-2005, 05:43 PM

Yes, they're nice.

They are very upgradeable. Everything but the valve is compatible with regular autococker parts, although if you want a new bolt (the stock bolt is very good already), you will have to replace the backblock at the same time.

som3 dud3 · 08-01-2005, 06:01 PM

Or you could buy an evo length bolt, I think.

tlmiller · 08-01-2005, 06:25 PM

No, because the o3m bolt and backblock have only a hole at the top, they do not have the side holes that most bolts require.

som3 dud3 · 08-01-2005, 06:28 PM

Oh yeah... I forgot about that. You're right.

dead_milkman · 08-01-2005, 06:55 PM

ive never seen these before.
anyone have a link and know how much they cost

r37r18u710n · 08-01-2005, 07:08 PM

I'm not absolutely positive this will work (I'm not all that familiar with Odysey markers), but the SLIK Edge III bolts have 4 holes, so as long as the back block and upper tube are the correct length for either the 2k+ or EVO length, the SLIK might work.

PaulO3M · 08-01-2005, 07:29 PM

There's no need to replace the stock bolt. They come with an open-faced delrin bolt that works just fine. Any improvement from replacing the bolt will be minimal at best in my opinion.

Paul

SSPB09 · 08-02-2005, 05:31 PM

Every thing on them is upgradable with ocker parts except for the valve, it uses a T1 valve. It also comes with eye holes drilled and a n eye cover incase you ever want to up to an e-blade