I always hated some of the features on the original geo. No room between the reg and trigger guard, those ugly "rail esc" humps on top, and the wierd flow of lines and curves the gun featured. So if you're looking for a why the project came to be, that would be it.
I knew upon getting this gun that it was going to be a project for me. I don;t have a CNC Mill or a lathe, just a file, dremel, and some sand paper. I'm no where close to being a profesional, but would like to get better at this as I go along.
Let me know what you think so far. If you have any questions, ask, and advice/CC is highly appreciated! I haven't polished the milled area's yet, since I will have to do the whole gun once I get some Lye.
Also PM me if you're an anodizer and would like to take it in as a project/courtesy job
Although that's unlikely, I do have money to get it anno'd, but sincerely don't wish to spend more then 100.