[dyepaint17]

So I got my invasion last week and fired her off out back and she was fine, I put a virtue OLED in her and took her to the field today and she went crazy. Shooting on her own and not shooting when I hit the trigger. Randomly under pressurizing and over pressurizing. Is this considered normal?

[spypaintball]

did u change any of the setting on the new board

[dyepaint17]

Not at first but I lowered the dwell and trigger sensitivity and it didn't do anything.

[griffan2]

Ah. Stock settings on the virtue boards are for bl guns i believe. You probably need to raise the dwell

[dyepaint17]

I dropped it from 6.6 to 3, that's what it looked like the invasion manual said.

[specopsdeath2]

raise the dwell to about 12. see how that works out.

raise the mechanical debounce as well for your trigger. set the trigger activation to about 3/4's through the pull

[dyepaint17]

Originally Posted by specopsdeath2

raise the dwell to about 12. see how that works out.

raise the mechanical debounce as well for your trigger. set the trigger activation to about 3/4's through the pull

What should I raise the mechanical denounce to?

[specopsdeath2]

Originally Posted by dyepaint17

What should I raise the mechanical denounce to?

What's the stock setting on it? I would raise it up maybe 5 from stock..not quite sure honestly. Really to where ever stops the gun from bouncing. Tinker with that setting a bit and see what works well.