I think any board that has a dwell and operates at the same voltage that runs an MQ would work.
But I have no idea what that voltage is. Good luck though, You may be able to adapt a cocker board into an angel frame, but I'm not sure of that either.
Most boards that have a cap should run it, unless its a ecocker...
__________________
This has been a TEST, This life has been a TEST.
Had this been an Actual LIFE you would had lived in
the Mountains, Never worked and SKIED EVERY DAY
I can say for certain that if you have a working cocker that shoots just fine you are one of the three, or all of the above. 1- you are not an idiot. 2- you know someone who is not an idiot. 3- you have enough money to pay someone who is not an idiot. - jonotwist
problem with most boards is that they are only designed to power 1 solenoid where as e-cockers have 2. also the sear solenoids/mq valves need a pretty good amount of juice so a cap is usually needed for it to work consistantly.
I hate resurrecting an old thread but I thought this might be fairly useful in the future if anyone is searching for it. Not only do you need a board that runs 2 solenoid but you need one which has a large dwell adjustment.
With that said, the most popular boards seem to be:
1. E2
2. Zero B
Boards that will not work:
1. E1
2. Scenario Dreams cocker board
3. Pandora for excal'/Viking
All these boards do not have enough dwell adjustment to properly time the mq2.
__________________
'07 Angel G7 Joy Division
'05 Dye DMC /w X94 bolt
'05 WGP Black Magic /w MQ2
'03 Dye Matrix /w X93 bolt
'01 Shocker Sport Turbo /w old school Maxflo 4500
Your Privacy Choices