[dtpbmasta]

ok guys i have a Wgp Vf Tactical, with a eframe 2 on it here is my issue i can get it to air up no leaks, shoots first shot pretty hot then after words will not recock it just puffs and the back block barely moves,

has a brand new battery went to 4 packs to make sure. turns on and the noid clicks just fine, setting are factory, unknown on velocity as it shoots only one time and its pretty hard and loud.

[cmdrsuds]

Sounds like the LPR is not high enough to re cock the gun. Make sure your IVG (large screw in the lower tube found in the rear of the gun) is screwed 1-2 turns in from flush when all the way out.

Set the board back to Factory Fast too then update us.

[cww516]

Sounds like it's getting starved for air somehow, make sure your reg is clean on the inside (might need a little grease or a rebuild), and try screwing the on/off knob on your ASA in or out a little (or do the same with the tank, if you don't have an on/off style ASA).

Edit: definitely check the LPR first.

[Dk-79]

After you check your LPR, make sure you didn't pinch any wires between the body and frame of your eblade. It'll cause the front solenoid to malfunction.

But check the LPR first.

[dtpbmasta]

tried what was said here is a video of issue at hand.

http://s595.photobucket.com/albums/t...t=c92c9ef8.mp4

[Dk-79]

You may have a piece of shell wedged between your bolt and feedneck.

Can you manually pull back the back block when the marker's not aired up?

[dtpbmasta]

yep and bolt moves freely and fine, nothing is in the breech or feedneck.

[Dk-79]

Either your LPR is low, or your noid wires are/were pinched between the trigger frame and body. Look it over for damage. Be careful putting it back together.

Assuming you're also using a new battery.

[dtpbmasta]

i will post tomorrow what i find and yes brand new battery is installed