[symes]

I have been using a Ninja HP Reg with my Demon & Luxe 2.0 with No problems
Will the 2013 Demon run on a LP Reg say 550 PSI sorry if this question as come up before
Thanks Symes

[WildWayz]

Yes - absolutely fine.

I used to run mine on a Ninja reg with all shims removed (450psi).

[symes]

Originally Posted by WildWayz

Yes - absolutely fine.

I used to run mine on a Ninja reg with all shims removed (450psi).

Thanks for that mate

[pinoyed]

550 isn't LP, just saying...

[Pr1m0]

550 is medium pressure. which is what MOST spools run perfectly on.
LP is getting closer to 350

[Reaper (ACI)]

Yup.
850 good
550 perfect
450 little low
350- too low

[xmc1146]

you should listen to this guy ^^^

i have a 2012 and mine runs perfecttO! on 450psi but you have a 2013 so i dont know about that one.

[juggernaught_lives]

Originally Posted by Reaper (ACI)

Yup.
850 good
550 perfect
450 little low
350- too low

My Demon did not like HP at all, it would act retarded. I found that the Sweet Spot for the Tank Pressure for performance for most Demons are between 400 and 600.

My Demon is quite unique in terms that it works with my SLP tank but not every Demon can function properly on SLP

[symes]

Thanks for your replies took the 2 Red shims out so should be 500 psi approx

[bcrguy]

im in the same boat. i just got a 2013 demon and im running a ninja tank and reg with 1 shim removed (~650) and im wondering now if i should take out both red shims and run at 500ish or stay at 650?

[juggernaught_lives]

Originally Posted by bcrguy

im in the same boat. i just got a 2013 demon and im running a ninja tank and reg with 1 shim removed (~650) and im wondering now if i should take out both red shims and run at 500ish or stay at 650?

I wouldn't change a thing unless you are having consistency issues, if not then you're fine.

[Reaper (ACI)]

If it goes bang when you pull the trigger, be happy and go play.

[bcrguy]

ok thanks guys. il run it as is now (650) and if i find it inconsistent then il take out the other shim.