Marker setup: When it ran co2 i had expansion chamber and drop foward, now that i run air these are no longer needed.
BOLT ONS/INS: For stock bore barrel i use my 1913 barrel with bipod attatched. During humid or days 80+ I use a 14inch
cp .893 bore. Callapsable buttstock. Stock front grip. Rap 4 offset mount with Tasco red do sight (appearences sight great for marking drop when using bright paint).
Using Rip clip.
Egrip board has been upgraded to a APE Rampage board. Great modification well worth it. I only use 3 shot, semi, and responsive.
Dwell at 9 , debounce at 18.
INSIDE the marker I have polished all the internals due to some wear ( Old marker) Stock powertube. Zero kick hammer from tech T
using silver spring from spring kit. "Flutes" On the valve caseing have been expanded front to back for better flow (like a port
polish).
machined "power cone" from steel and polished (this makes less volume in the tube, less volume= more compression like
milling a cylinder head) These mods were done to get fps up from the loss i took from the zerokick hammer. It worked, if you are wondering.
With the above modification i went from tedious 22bps (had to shoot slowly to not chop) to going through 4 hoppers no chops ramping. I can now shoot 3 shot burst 25 bps as long as i don't walk the trigger or let it kick into ramp.