Does The Racegun Have Intellifeed Wire?

Junk · 04-23-2002, 09:53 PM

pbjosh · 04-24-2002, 03:01 AM

Junk!

Yup, they just finished a batch and I have some coming in on the next order.

Josh

orangejulius · 04-24-2002, 01:57 PM

but will it be where you still use the 12 V from the rev and just attach the wires to make the loader spin ever pull?

Nicad · 04-25-2002, 08:52 AM

without knowing 100%, Im pretty sure they arent able to run the hopper directly off of the racegrip's battereys.. so yes, itll prolly just be a 'signal' wire.

pbjosh · 04-25-2002, 10:45 AM

Nicad is right,

I mean, do you WANT to run your Warp from your 4.8 NiMH? Even the Angel just sends a signal.

Josh

Nicad · 04-26-2002, 09:56 AM

pbjosh-
I gotta jump back in here again and be slightly off topic...
about the angel intellifeed, im a bit confused. Im pretty sure it actually sends a full juice shot out the port.. and you wire it directly to your revvy's motor, thus eleminating your hopper's batteries. Iv physically seen them setup and work like this.

however, from trying to wire my own (didnt buy an intellifeed kit) it will not spin the motor... so im starting to doubt myself... or maybe my motor or my brain is fried.. hehe

anywho, just thought id toss that in.
out!

mezpo · 05-02-2002, 09:41 PM

yes angel intellifeed runs the hopper from the guns power source. You remove your rev batteries when you are using intellifeed.

mezpo · 05-02-2002, 11:06 PM

We wired our own lcd intellifeed cables. I cant remember what wires we ran it to off hand....id have to look at one. Making and intellifeed cable for the race should be very simple if it is just closing the circuit. That would mean you could just solder your wires in place of the eye in the hopper. I will look into what it would take once i get my race. Hopefully either tomorrow or saturday!!!!

mezpo · 05-08-2002, 12:43 PM

After talking to morten from racegun, to make intellifeed work for a revvy a relay and small circuit would have to be created since the rev does not have an input for a signal like the warp feed does. Im looking into how this can be implemented and i will let you guys know if i come up with anything.

Dubstar112 · 05-10-2002, 06:18 PM

Got $40 and some useless talent? Buy a warpfeed circuit board, and rig it into the revvy, this way you can set dwell, and intellifeed super easy.

mezpo · 05-10-2002, 08:09 PM

hmmm interesting idea.