[phelixcubed]

Hey, all - I was wondering how I would go about removing the entire trigger assembly out of a stock Mag carbon fiber trigger frame. I can't seem to find any how-to literature online, and the video and manual I have are woefully inadequate when it comes to this. There looks like a 1mm hey key stop above the trigger safety - that needs to be removed, right? After that, do I need to pop the pin out using a hammer? Any advice anyone could give would be appreciated.

[cyberave68]

The pin just above the trigg is what holds it in place. You can use a nail an hammer to push it out. Be carefull as it only comes out one way. The pin has a couple of high spots on one end to keep it on place. I sugest tapping out slowly to see if you have it going the right way. Any other questions you can PM me...

Cy

[gunangel]

yes and yes
remove the hex key and pull out the spring ball bearing
knock out the pin with a drift punch remove the trigger and the safety cam

do it somewhere flat and clean, if you lose a piece it will be a pain to find.

[Army]

Knock everything out on a towel. Nothing will roll away.