Has anyone here successfully bored a DP barrel for freak inserts? I'm looking at the 0.693 rev-i barrel, but when I asked SSC at MCB, he was concerned the middle of the barrel's OD wasn't round and flat enough to hold safely.
__________________
"Memory is cheap." -Dr. Sam Kassegne
Has anyone here successfully bored a DP barrel for freak inserts? I'm looking at the 0.693 rev-i barrel, but when I asked SSC at MCB, he was concerned the middle of the barrel's OD wasn't round and flat enough to hold safely.
you can try odells. they are supposed to be able to bore barrels for freak inserts also.
__________________ Reverse Poison 2K12 Bob Long G6R DP G3 Spec r W/ Techt Bolt Engine, VP Deuce Trigger, and a 7E OLED Board
2K2 Vert. Feed Autococker W/ CCM Pump Kit and Gat Products A/T
I had my G4 barrel done. I don't know if they are the same. I believe Tymcneer from MCB did mine.
__________________
** If your parents can't pay for your paintball stuff because they are too old and their social security checks are used to fund their retirement, put this in your signature**
Your Privacy Choices