[Wild Huntsman]

Hello Impulsers!

A buddy of mine just picked up an Atomix Impulse from his uncle who apparently quite playing a while ago. It was missing a poppit spring (which i found at a hardware store) and the reg (a WGP reg) was shot, but I've put a Hyper II on it for the time being to tech it, and was able to get it to stop leaking after about 15 minute.

The only problem that I am having is with the WAS board. For some reason it only gives me full color feedback (red/green/orange) when the electronics tray is seperated from the gun. When everything is put together it only flashes red (though it does cycle with trigger pulls). The trigger pulls are only displayed by flashing lights when the tray is seperated from the gun. The eyes don't seem to register anything either, board on or off the gun.

Do any of you guys happen to know what could be causing this? Also, I've been looking for a impulse WAS manual but can't find any online (yes, I've checked Google, WAS's website [links wouldnt open], and pbnation). Any help finding one would be greatly appreciated.

[msonic]

impusagemanual.doc (67 KB)

I guess it is time to update a Sticky thread with all the manuals available.

Sounds almost like you are stuck in programming mode? Pinched/crushed wire anywhere? Sounds like the eye might be bad as well...

[Ken448]

or the trigger is adjusted wrong maybe. I know you say itll register when separated, but when you install it doesnt, if it has a REALLY short pull, it can mess up when you attach the 2 halves

[Wild Huntsman]

Originally Posted by Ken448

or the trigger is adjusted wrong maybe. I know you say itll register when separated, but when you install it doesnt, if it has a REALLY short pull, it can mess up when you attach the 2 halves

The trigger is fine... the gun fires perfectly when put together, its just that the green light doesnt function.

thanks for the link, ill check it out tonight!