Quote:
Originally Posted by Nickdennis
Sorry was at EMR all weekend. Bolt is not upside down, and I checked the wires and they are not pinched. Also I have a PE OOPS ASA on it and it is screwed in all the way for the air.
|
try unscrewing the tank just a hair, sometimes an asa's pin can push the tanks valve pin in so far it actually blocks air flow.
sounds like the hammer lug might need adjusting. take the grips off, cock the gun, and push up on the little plate on the sear solenoid. it should release the hammer about half way through its travel.
also make sure the sear-on setting didnt get turned down low. 3.5 or 4 works great.